VLX: Toggle Encoder/Decoder Mode by Chris Koerner NOTE: The following article pertains to VLX firmware versions prior to 3.20.0. For 3.20.0 and newer, please refer to the update at the bottom of this article. The VLX transceiver provides an API comma... AV over IP VLX
VLX/VPX/IPX: Point-to-Point operation by Chris Koerner Editor's note: this article was originally written focused on VLX, but the general concept applies to VLX, VPX, and IPX products. For point-to-point applications, you can set two VLX units to stream w... AV over IP IPX VLX VPX
VLX: Channel Mapping by Chris Koerner Channel mapping is a feature that allows you to assign VLX streams to a virtual channel, much like a TV tuner. Once enabled, you can use the channel up/down buttons on the Aurora IRC-11 IR remote cont...
VLX: Secondary firmware mode by Chris Koerner If a VLX's firmware becomes corrupt due to a failed update and becomes inaccessible on the network, you may be able to recover it by entering secondary firmware mode. For VLX-TCW2V-C and VLX-TCW2H-C, ... AV over IP VLX
VLX/VPX: Raspberry Pi always selected as active input when plugged in by Chris Koerner Editor's note: this article was originally written focused on VLX, but the general concept applies to VLX and VPX products. If you have used a Raspberry Pi with a VLX, you may have noticed that the VL... AV over IP VLX VPX
IPX: Video bandwidth calculation by Chris Koerner When configuring an IPX system with more than one network switch, bandwidth calculations must be performed to ensure that your uplinks do not get saturated. For example, if you have two switches with ... AV over IP IPX